68
UserManualforELD2Servo
P901-P902
Position
P901 for high 16bit，P902 for low 16bit.
P903
Speed running speed, rpm
P904
Acceleration time Unit: ms/1000rpm
P905
Deceleration time Unit: ms/1000rpm
P906
Pause time Pause time after Instruction stop
P907
Special Parameters Path 0 mapped to Pr8.02 directly
And so on
Each path occupy eight parameters and so on
Time sequence
Single segment running:
Continuous operation
P9.00 bit5 is 0, continuous path does not overlap
路径
:
不重叠连续路径
PR1
速度停止
DELAY1
PR2
PR2
到位:
To Next Page
Loading...