X75HD Installation and Operation Manual 79
Chapter 5: Initial Configuration
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Configuration Exceptions and Further Information
There are a few exceptions to the input source/output group mapping
process described in the previous sections, including the following:
• “Mutually Exclusive Inputs”
• “AllOutSelect Limitations”
• “Advanced Routing Configurations”
Mutually Exclusive Inputs
Several input settings are mutually exclusive. For example, the back of
the X75HD allows for up to three HD input sources; however, only one
of these inputs sources can be accepted at a time. In this example, all
output groups must be set to the same HD input type, not to three
different input types. If you attempt to map different HD inputs to
various output groups, only the last setting you make will apply.
Previous HD input mappings will change to reflect the last setting.
This scenario of mutually exclusive HD inputs also applies to the
following input types:
• SDI2 and DV
• Analog (Composite, CAV, and S-video)
These groupings are not independent inputs. Only one input type in
each of these groups can be selected for each output group.
AllOutSelect Limitations
The AllOutSelect control lists all available input sources. But in cases
where you have manually assigned different input sources to various
output groups, then AllOutSelect will not able to reflect a single input
type. Instead, M-Path control is selected.
When you manually configure any of the M-Path menu output groups,
then AllOutSelect control will change over the M-Path control.
Note that if you change AllOutSelect to a single input type, and you
return to AllOutSelect control, then all manual changes done
previously during M-Path configuration will be overridden.
To Next Page
Loading...
