X75HD Installation and Operation Manual 61
Chapter 4: System Installation and Connections
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
DVI-D Output
This connector, labelled DVI-D, is a digital-only transmitter that
provides up to 330 MHz bandwidth signal and supports 1080i/29.97,
1080i/25, 1080i/59.94, 1080i/50, 720p/59.97, 480i/29.97, and 576i/25
outputs. Connect an optional CAB-X75-DVI DVI-D to DVI-D (digital,
single-link) cable between the appropriate port and a customer-supplied
monitor.
Composite Video Input
This BNC connector, labeled CMPST, is used to feed composite 1 V
pk-to-pk 75W video to the X75HD. The input video signal must be
direct color or monochrome (such as from a satellite feed or live
camera).
S-Video Input
This four-pin mini-DIN connector, labeled S-VIDEO, is used for
S-video (Y/C) signals, such as from an S-VHS or Hi-8 device. It is
normally connected to the S-video output of a playback VTR.
Component Analog Video Inputs
These three BNC connectors, labeled CAV-Y IN, R-Y IN, and B-Y IN,
are used to input the signals from analog component devices, such as
Betacam VTRs.
Audio Connections
On X75HD systems equipped with an HDTV audio option, up to eight
stereo channels can be processed from any of the following inputs:
• 4 x analog mono channels
•5 x AES
• 1 x DV stereo channel
• SDTV embedded (four groups, sixteen mono channels)
• HDTV embedded (four groups, sixteen mono channels)
To Next Page
Loading...
