124 X75HD Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 9: Controlling the X75HD via Web Server Software
Monitoring Alarms
Click Monitoring from the Home page to open the X75 Alarms page
and view or change the status of various of alarms and events. (See
Figure 9-8 on page 125.)
The Alarms table groups alarms and events into the following
categories: Active Alarms, Inactive Alarms, and Disabled Alarms.
• Apply the Disabled designation to those alarms you do not want
reported.
Disabled alarms are listed in Disabled Alarm list at the bottom of
the table.
• The Inactive designation is applied automatically to those items that
do not have an alarm associated with them.
• An Active designation means that an alarm is detected.
Alarms listed under the Inactive Alarms or Active Alarms categories
are always enabled. To change the status of an alarm, follow one of
these procedures:
• To disable an alarm, click Disable from the Action column for the
appropriate alarm.The alarm will then move to the Disabled Alarms
list at the end of the table.
• To enable an alarm from the Disabled Alarms list, click Enable
from the Action column for the appropriate alarm. The alarm will
then return to either the Active Alarms or Inactive Alarms list.
For all alarm categories, the name of the alarm is reported in the
Alarm Name column along side the associated Alarm_Priority level.
To Next Page
