X75HD Installation and Operation Manual 133
Chapter 11: Configuring Audio
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Selecting an Audio Source
Directly press the Audio In button to select any one set of audio inputs
to be sent out to all audio multiple output sets. The LEDs to the top,
right side of this button indicate which input is currently selected.
Adjusting Audio Levels
When a single audio source is selected and sent to all outputs, press the
Ctrl and A. Proc buttons to quickly access the audio level controls of
the selected audio input.
The selected audio input channels’ Gain controls are mapped to the
numbered buttons on the control panel accordingly. The mapped
buttons will illuminate during audio proc control. The audio Proc LEDs
on the lower, right corner of the front panel indicate which processing
block is currently selected.
To Next Page
