Leitch X75HD - Page 95

X75HD Installation and Operation Manual 71
Chapter 5: Initial Configuration
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Setting the IP Address of a Single Unit
Follow these steps to configure X75HD IP and subnet mask addresses:
1. Apply power (plug in) an X75HD unit with a frame-mounted local
control panel (LCP).
When ready for configuration, the X75HD main menu shows on the
display screen.
2. Press the Option button on the LCP.
3. Use the panel knob to scroll to the Setup menu, and then press
Enter.
4. Locate and scroll to the Panel IP parameter, and then press Enter.
If this is a new unit being configured, the default IP displays.
Otherwise, the current IP address of the unit displays.
5. Change the IP address, following these steps:
a. Press Enter to navigate to one of the four numerical items in
the octet.
b. Modify the address value by using the scroll knob to set a new
number.
c. Press Enter to move to the next item in the octet, and then
repeat step b above.
d. Press Exit when you are finished configuring the address.
6. Press Exit to return to the Setup menu.
7. Locate and scroll to the Subnet Mask parameter, and then press
Enter.
If this is a new unit being configured, the default subnet mask
displays. Otherwise, the current subnet displays.
8. Follow the same procedure as described in step 5.
9. Locate and scroll to the Gateway parameter, and then press Enter.
If this is a new unit being configured, the default gateway displays.
Otherwise, the current gateway address displays.
10. Follow the same procedure as described in step 5.
11. Restart the X75HD unit.
To do this, navigate to the Setup menu, select Reboot, and then
press Enter. To restart an X75HD unit with a blank front panel,
unplug it and then reapply power.