X75HD Installation and Operation Manual 75
Chapter 5: Initial Configuration
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
6. To switch to another unit, or to control the local device you are
physically operating, click Remote, and then select a new device to
control. Select <local device> to resume normal single-unit
operation.
Using a Frame-Mounted Local Control Panel for Remote Operation
After ensuring that all connections and network settings have been
made, you can also remotely control X75HD units that are on the
network using a frame-mounted local control panel (LCP). To do this,
click Remote on the LCP to enter Remote mode, and to view the list of
X75HD units available for control on the same subnet. The procedure
remains the same for selecting and operating devices remotely via LCP
as for the RCP-X75.
See “Using an RCP-X75 for Remote Operation” on page 74 for details.
To Next Page
Loading...
