To Next Page

To Previous Page

Binding the New Switch to the Stack

1. Logintothestackinterface.

Note: IfreplacingtheMasterswitch,besuretologintothestackinterface(hosted

temporarilyontheBackupswitch)ratherthanloggingindirectlytothenewly

installedMaster.

2. Fromthestackinterface,assignthecsnumforthenewswitch.

YoucanbindMember

switchestoastackcsnumusingeitherthenewswitch’s

asnumorMACaddress:

Note: IfreplacingtheMasterswitch,theMasterwillnotassumecontrolfromthe

BackupunlesstheBackupisrebootedorfails.

CN 4093(config)# stack switch-number <csnum> universal-unic-id <uuid> bay

<SlotID>

‐or‐

CN 4093(config)# stack switch-number <csnum> bind <asnum>

‐or‐

CN 4093(config)# stack bind

Lenovo Flex System Fabric CN4093 User Manual

Other manuals for Lenovo Flex System Fabric CN4093