To Next Page

To Previous Page

574 CN4093 Application Guide for N/OS 8.4

Loading a New Switch Image

Toloadanewswitchimagewiththename“MyNewImage-1.img”intoimage2,

followthestepsbelow.ThisexampleshowsanFTP/TFTP/SFTPserveratIPv4

address192.168.10.10,thoughIPv6isalsosupported.

1. SettheFTP/TFTP/SFTPserveraddresswheretheswitchimageresides:

Set agTransferServer.0 "192.168.10.10"

2. Settheareawherethenewimage

willbeloaded:

Set agTransferImage.0 "image2"

3. Setthenameoftheimage:

Set agTransferImageFileName.0 "MyNewImage-1.img"

4. IfyouareusinganSFTP/FTPserver,enterausername:

Set agTransferUserName.0 "MyName"

5. IfyouareusinganSFTP/FTPserver,enterapassword:

Set agTransferPassword.0 "MyPassword"

6. Initiatethetransfer.Totransferaswitchimage,enter2(gtimg):

Set agTransferAction.0 "2"

Loading a Saved Switch Configuration

Toloadasavedswitchconfigurationwiththename“MyRunningConfig.cfg”into

theswitch,followthestepsbelow.ThisexampleshowsaTFTPserveratIPv4

address192.168.10.10,thoughIPv6isalsosupported.

1. SettheFTP/TFTP/SFTPserveraddresswheretheswitchConfig urationFileresides:

Set agTransferServer.0 "192.168.10.10"

2. Setthenameoftheconfiguration

file:

Set agTransferCfgFileName.0 "MyRunningConfig.cfg"

3. IfyouareusinganSFTP/FTPserver,enterausername:

Set agTransferUserName.0 "MyName"

4. IfyouareusinganSFTP/FTPserver,enterapassword:

Set agTransferPassword.0 "MyPassword"

5. Initiatethetransfer.Torestorearunningconfiguration,enter3:

Set agTransferAction.0 "3"

Lenovo Flex System Fabric CN4093 User Manual

Other manuals for Lenovo Flex System Fabric CN4093