To Next Page

To Previous Page

Enabling or Disabling LLDP

Global LLDP Setting

Bydefault,LLDPisenabledontheCN4093.ToturnLLDPofforon,usethe

followingcommand:

Transmit and Receive Control

TheCN4093canalsobeconfiguredtotransmitorreceiveLLDPinformationona

port‐by‐portbasis.Bydefault,whenLLDPisgloballyenabledonthe switch,

CN4093portstransmitand receiveLLDPinformation(seethetx_rxoption

below).TochangetheLLDPtransmitandreceivestate,thefollowingcommands



areavailable:

ToviewtheLLDPtransmitandreceivestatus,usethefollowingcommands:

CN 4093(config)# [no] lldp enable (Turn LLDP on or off globally)

CN 4093(config)# interface port <x> (Select a switch port)

CN 4093(config-if)# lldp admin-status tx_rx (Transmit and receive LLDP)

CN 4093(config-if)# lldp admin-status tx_only (Only transmit LLDP)

CN 4093(config-if)# lldp admin-status rx_only (Only receive LLDP)

CN 4093(config-if)# no lldp admin-status (Do not participate in LLDP)

CN 4093(config-if)# exit (Exit port mode)

CN 4093(config)# show lldp port (status of all ports)

CN 4093(config)# show interface port <n> lldp (status of selected port)

Lenovo Flex System Fabric CN4093 User Manual

Other manuals for Lenovo Flex System Fabric CN4093