Lenovo Flex System Fabric CN4093 User Manual

346 CN4093 Application Guide for N/OS 8.4
Example 2: Full Fabric FC/FCoE Switch
ConsiderthefollowingFibreChannelnetwork:
Figure 36. Usingthe
CN4093 asaFullFabricFC/FCoESwitch
Inthisexamplenetwork,theCN4093actsasthefullfabricswitchfortheFibre
Channelnetworkintwozones.
Note: Althoughupto12FibreChannelVLANscanbeconfiguredontheswitchat
anygiventime,onlyonecanoperateinfullfabricmode.
Therestmay be
configuredasNPVgateways.Forinstance,thefullfabricconfigurationinthis
examplecanbeusedsimultaneouslywithupto11NPVgatewaysconfiguredas
shownintheNPVexampleonpage 346.
1. SpecifywhichOmniPortswillbeusedforFibreChanneldevices:
Note: Onthe
CN4093, FibreChanneldevicescanbeconnectedonlytoOmniPorts.
OmniPortsconnectedtoFCoEdevicesareconsideredpartoftheEthernetnetwork
andshouldbelefttooperateinEthernetmode.
2. Enabletagging/trunkmodeforinternalportsparticipatinginFCoE:
3. SpecifyallmemberportsfortheVLAN:
Note: Atleastone
FibreChannelportmustbeincluded.
4. SpecifyaVLANforthethisFibreChannelnetwork:
FCoE
FCoE
FCoE
FCoE
Zone1
Zone1
Zone1
Zone2
Zone1/2
Zone2
Lenovo
Converged
Switch
INTA5
INTA6
INTA7
INTA8
EXT13
EXT14
Lenovo Chassis
Fibre Channel
Storage
Fibre Channel
Server
CN 4093(config)# system port ext13-ext14 type fc
CN 4093(config)# interface port inta5-inta8
CN 4093(config-if)# switchport mode trunk
CN 4093(config-if)# exit
CN 4093(config)# interface port inta5-inta8
CN 4093(config-if)# switchport trunk allowed vlan add 200
CN 4093(config-if)# exit
CN 4093(config)# interface fc ext13-ext14
CN 4093(config-if)# switchport trunk allowed vlan add 200
CN 4093(config-if)# exit
CN 4093(config)# vlan 200

Lenovo Flex System Fabric CN4093 Specifications

General

Brand	Lenovo
Model	Flex System Fabric CN4093
Category	Switch
Language	English