Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Align the power distribution board slots
1 with the alignment pins 2 and lower it into the server;
then, slightly slide the power distribution board forward to insert it.
Figure 98. Power distribution board installation
Step 2. Fasten the two screws to secure the power distribution board.
Figure 99. Screw installation
Step 3. Connect the cables to the power distribution board. See “Hot-swap power supply unit cable
routing” on page 39
.
Step 4. Align the power distribution board cover pin
1 with the hook 2 and lower it into the server; then,
slightly slide the power distribution board cover backwards to insert it.
112 ThinkSystem SR250 V2 Maintenance Manual
To Next Page
Loading...
