Figure 100. Power distribution board cover installation
Step 5. Fasten the two screws to secure the power distribution board cover.
Figure 101. Cover screw installation
After you finish
1. Install the flash power module. See
“Install the flash power module” on page 80.
2. Connect the flash power module cable to the RAID adapter. See
“Flash power module cable routing” on
page 40
.
3. Install the power supply unit. See
“Install a hot-swap power supply unit” on page 107.
4. Install the top cover. See
“Install the top cover” on page 134.
5. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
Chapter 4. Hardware replacement procedures 113
To Next Page
Loading...
