Lenze E82EV751K4C User Manual

Glossary
Meaning of the signal names
2
Guide
2.2
2.2.2
L
2.2-4
EDS82EV903-1.0-11/2002
DCTRL1-NOUT=0
DCTRL1- speed output = 0
Status signal:
Output frequency = 0 Hz
DCTRL1-OH-WARN DCTRL1- overheat warning
Warning signal:
Overtemperature
DCTRL1-OH-PTC-LP1-FAN1-WARN DCTRL1-warning: overheat or motor temperature or lost
phase or fan failure
Warning signal:
Overtemperature or motor temperature too high or motor phase
or fan have failed
DCTRL1-OV DCTRL1-ov ervoltage
Warning signal:
DC bus overvoltage
DCTRL1-PAR-B0 DCTRL1- parameter set 2 or 4 active
Status signal:
Parameterset2or4active
DCTRL1-PAR-B1 DCTRL1- parameter set 3 or 4 active
Status signal:
Parameterset3or4active
DCTRL1-PAR2/4 DCTRL1- activation of parameter set 2 or 4
Activates parameter set 2 or 4
DCTRL1-PAR3/4 DCTRL1- activation of parameter set 3 or 4
Activates parameter set 3 or 4
DCTRL1-PTC-WARN DCTRL1-motor temp erature warning
Warning signal:
Motor temperature too high
DCTRL1-QSP DCTRL1- activation of quickstop
Activates quickstop
DCTRL1-RDY DCTRL1 ready
Status signal:
Ready for operation
DCTRL1-RFG1=NOUT DCTRL1- RFG1 = speed output
Status signal:
Frequency setpoint has been reached
DCTRL1-RUN DCTRL1 -motor is running
Status signal:
Motor runs
DCTRL1-RUN-CCW DCTRL1-motor runs counter-clockwise
Status signal:
Motor runs/CCW rotation
DCTRL1-RUN-CW DCTRL1-motor runs clockwise
Status signal:
Motor runs/CW rotation
DCTRL1-TRIP DCTRL1- TRIP active
Status signal:
Fault message (TRIP) active
DCTRL1-TRIP-QMIN-IMP DCTRL1-TRIPorQminorIMPactive
Status signal:
TRIP or Qmin have not been reached or pulse inhibit active
Show/Hide Bookmarks

Lenze E82EV751K4C Specifications

General

Brand	Lenze
Model	E82EV751K4C
Category	DC Drives
Language	English