Lenze EPM-T110 - Reset Node

Reset node
10
Network via CANopen
10.9
l
10.9-1
EDSPM-TXXX-3.0-04/2004
10.9 Reset node
Changes of transmission modes and identifiers will be accepted after ”reset node”
only.
z Switch the supply voltage on again
z Execute NMT command ”81
h
” (see chapter ”Network management (NMT)”)
z Set I2358
h
=1
Index Name Possible settings Important
Lenze Selection
I2358
h
CAN reset node 0
0 No function
Reset node E 10.9-1
h
1 CAN reset node
Show/Hide Bookmarks