EasyManua.ls Logo

Lenze EPM-T110 - Parameter setting

Lenze EPM-T110
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents
12
Parameter setting
12.1
l
12.1-1
EDSPM-TXXX-3.0-04/2004
12 Parameter setting
12.1 Contents
12.2 Parameterising digital modules 12.2-1................................................
12.2.1 Parameter data 12.2-1...................................................
12.3 Parameterising analog modules 12.3-1...............................................
12.3.1 Parameter data 12.3-1...................................................
12.3.2 Diagnostic data 12.3-6..................................................
12.3.3 Input data / output data 12.3-7.............................................
12.3.4 Signal functions of 4xanalog input 12.3-7.....................................
12.3.5 Signal functions of 4xanalog output 12.3-11....................................
12.3.6 Signal functions of 4xanalog input /output 12.3-13...............................
12.3.7 Converting measured values for voltage and current 12.3-16........................
12.4 Parameterising 2/4xcounter module 12.4-1............................................
12.4.1 Parameter data 12.4-1...................................................
12.4.2 Input data / output data 12.4-4.............................................
12.4.3 2 x 32 bit counter (mode 0) 12.4-6..........................................
12.4.4 Encoder (modes 1, 3, and 5) 12.4-8.........................................
12.4.5 Measuring the pulse width, fref 50 kHz (mode 6) 12.4-12..........................
12.4.6 4 × 16 bit counter (modes 8 ... 11) 12.4-14....................................
12.4.7 2 × 32 bit counter with GATE and RES level-triggered (mode 12 and 13) 12.4-16.........
12.4.8 2 × 32 bit counter with GATE, RES level-triggered and auto reload (mode 14 and 15) 12.4-19
12.4.9 Measuring the frequency (modes 16 and 18) 12.4-22.............................
12.4.10 Measuring the period (modes 17 and 19) 12.4-26................................
12.4.11 Measuring the pulse width, fref programmable (mode 20) 12.4-29....................
12.4.12 Measuring the pulse width with GATE, fref programmable (modes 21 and 22) 12.4-32......
12.4.13 2 × 32 bit counter with GATE and set/reset (modes 23 ... 26) 12.4-35.................
12.4.14 2 x 32 bit counter with G/RES (mode 27) 12.4-39................................
12.4.15 Encoder with G/RES (modes 28 ... 30) 12.4-41..................................
12.4.16 2 × 32 bit counter with GATE and RES edge-trigge red (mode 31 and 32) 12.4-45.........
12.4.17 2 × 32 bit counter with GATE, RES edge-triggered and auto reload (mode 33 and 34) 12.4-48
12.4.18 2 x 32 bit counter with GATE (mode 35) 12.4-51.................................
12.4.19 Encoder with GATE (modes 36 ... 38) 12.4-53...................................
Show/Hide Bookmarks

Table of Contents

Related product manuals