Lenze L-force 8400 BaseLine D - Page 194

8400 BaseLine D | Software Manual
Parameter reference
Parameter list | C00158
194 L Firmware 03.00 - DMS EN 5.0 - 07/2009
C00158
Parameter | Name:
C00158 | Cause of controller inhibit
Data type: UNSIGNED_16
Index: 24417
d
= 5F61
h
Bit coded display of the cause/source of controller inhibit
Display range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded:
Bit 0 Terminal controller enable
Bit 1 Reserved
Bit 2 Reserved
Bit 3 Reserved
Bit 4 Application
Bit 5 Controller command
Bit 6 Error response
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 AutoStartLock
Bit 11 Motor parameter identification
Bit 12 Reserved
Bit 13 DCB-IMP
Bit 14 Reserved
Bit 15 Reserved
; Read access  Write access  CINH  PLC STOP ; No transfer  COM  MOT