Lenze L-force 8400 BaseLine D User Manual

8400 BaseLine D | Software Manual
Overview of the technical documentation for Inverter Drives 8400
2 L Firmware 03.00 - DMS EN 5.0 - 07/2009
Overview of the technical documentation for Inverter Drives 8400
Project planning, selecting & ordering Legend:
 8400 Hardware Manual  Printed documentation
 Catalogue  Online documentation
(PDF/»Engineer« online help)
Mounting & wiring Abbreviations used
 MA 8400 BaseLine/8400StateLine/HighLine BA Operating Instructions
 MA for communication module KHB Communication Manual
 MA for extension module MA Mounting Instructions
 MA for safety module SW Software Manual
 MA for accessories
Parameter setting
 BA keypad
 SW 8400 BaseLine C
 SW 8400 BaseLine D Í This documentation
 SW 8400 StateLine
 SW 8400 HighLine
 KHB for communication module
Commissioning of the drive
 Commissioning guide
 SW 8400 StateLine/HighLine
 Chapter "Commissioning"
 Chapter "Oscilloscope"
 Chapter "Diagnostics & fault analysis"
Networking
 KHB for communication medium used

Lenze L-force 8400 BaseLine D Specifications

General

Product Series	L-force 8400 BaseLine D
Category	Inverter Drive
Protection Class	IP20
Enclosure Rating	IP20
Rated Power	Depends on model (0.37 kW to 22 kW)
Output Voltage	3-phase 0 to input voltage
Control Method	U/f control, vector control
Communication Interfaces	CANopen
Operating Temperature	-10°C to +50°C
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit, overheating
Dimensions	Varies by model
Weight	Varies by model