Lenze L-force 8400 BaseLine D - Page 209

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 209
8400 BaseLine D | Software Manual
Parameter reference
Parameter list | C00621
C00621
56 LA_NCtrl_nMotorTorqueAct_a
57 LA_NCTRL_nHeatsinkTemperature_
a
70 LA_NCTRL_wDeviceStateWord
71 LA_NCTRL_wDeviceAuxStateWord
72 LA_NCTRL_wDetermFailNoLow
73 LA_NCTRL_wDetermFailNoHigh
Subcodes Lenze setting Info
C00620/1 0: Not connected Reserved
C00620/2 0: Not connected Reserved
C00620/3 0: Not connected Reserved
C00620/4 0: Not connected Reserved
C00620/5 0: Not connected LS_DisFree: wDis1
C00620/6 0: Not connected LS_DisFree: wDis2
C00620/7 0: Not connected LS_DisFree: wDis3
C00620/8 0: Not connected LS_DisFree: wDis4
C00620/9 0: Not connected LS_DisFree_a: nDis1_a
C00620/10 0: Not connected LS_DisFree_a: nDis2_a
C00620/11 0: Not connected LS_DisFree_a: nDis3_a
C00620/12 0: Not connected LS_DisFree_a: nDis4_a
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00620 | 16-bit system connection
Data type: UNSIGNED_16
Index: 23955
d
= 5D93
h
Parameter | Name:
C00621 | Bool system connection
Data type: UNSIGNED_16
Index: 23954
d
= 5D92
h
Connection parameters: Binary inputs
• Selection of the binary output signals for connection with the binary input signals.
• The selection list contains all binary output signals which can be assigned to the binary inputs mapped by the
subcodes.
Selection list Info
0Not connected
1C_bTrue
11 DigIn_bIn1
12 DigIn_bIn2
13 DigIn_bIn3
14 DigIn_bIn4
15 DigIn_CInh
20 bPar1
21 bPar2
22 bPar3
23 bPar4
24 bPar5
25 bPar6
26 bPar7
27 bPar8
28 bPar9