Leuze electronic RSL 420P - Laser Safety Notices

Safety
Leuze electronic GmbH + Co. KG RSL 420P 12
2.4 Disclaimer
LeuzeelectronicGmbH+Co.KG is not liable in the following cases:
• The safety sensor is not used as intended.
• Safety notices are not adhered to.
• Reasonably foreseeable misuse is not taken into account.
• Mounting and electrical connection are not properly performed.
• Proper function is not tested (see chapter 12 "Testing").
• Changes (e.g., constructional) are made to the safety sensor.
2.5 Laser safety notices
Laser class1 for wavelength range outside 400-700 nm
NOTICE
Additional measures for shielding the laser radiation are not necessary (safe for eyes).
ATTENTION
LASER RADIATION – CLASS 1 LASER PRODUCT
The device satisfies the requirements of IEC60825-1:2014 / EN60825-1:2014+A11:2021 safety
regulations for a product of laser class1 and complies with 21CFR1040.10 except for confor-
mance with IEC60825-1Ed.3., as described in Laser Notice No.56, dated May8,2019.
Ä Observe the applicable statutory and local laser protection regulations.
Ä The device must not be tampered with and must not be changed in any way.
There are no user-serviceable parts inside the device.
CAUTION! Opening the device may result in hazardous radiation exposure!
Repairs must only be performed by LeuzeelectronicGmbH+Co.KG.
2.6 Responsibility for safety
Manufacturer and operator must ensure that the machine and implemented safety sensor function properly
and that all affected persons are adequately informed and trained.
The type and content of all imparted information must not lead to unsafe actions by users.
The manufacturer of the machine is responsible for:
• Safe machine construction and information on any residual risks
• Safe implementation of the safety sensor, verified by the initial test performed by a competent person
• Imparting all relevant information to the operating company
• Adhering to all regulations and directives for the safe commissioning of the machine
The operator of the machine is responsible for:
• Instructing the operator
• Maintaining the safe operation of the machine
• Adhering to all regulations and directives for labor protection and safety at work
• Regular testing by competent persons