Leuze electronic RSL 420P - PC Connection Methods

Configuring the safety sensor
Leuze electronic GmbH + Co. KG RSL 420P 77
NOTICE
The configuration data is stored in the connection unit of the safety sensor and is therefore also
available after replacement or repair of the scanner unit. The configuration data only needs to
be transferred again if changes are made to the configuration.
9.2 Connecting safety sensor to PC
9.2.1 Connection via Ethernet cable
Ä Connect the Ethernet cable to the PC or to the network; see the document "Quick Start Guide
RSL400".
Ä Define the IP address of the device using an external tool (e.g. PRONETA from Siemens).
Ä Enter the IP address of the device directly in the Sensor Studio communication DTM and start commu-
nication.
NOTICE
The TCP/IP protocol is used for communication via Ethernet.
9.2.2 Connection via Bluetooth
Prerequisites: Bluetooth communication of the safety sensor has been activated (see chapter 9.2.4 "Com-
munication between safety sensor and PC")
Ä Activate the Bluetooth interface on the PC.
Ä Select the safety sensor as the device for the Bluetooth connection.
NOTICE
Distance between safety sensor and PC
The possible distance between safety sensor and PC depends on the quality of the Bluetooth
adapter that is used.
USB Bluetooth adapters with external rod antenna enable a larger operating range.
9.2.3 Connection via USB
The USB interface is behind a protection cap on the front of the safety sensor.
NOTICE
Distance between safety sensor and PC with USB connection!
The USB interface of the safety sensor is connected to the USB interface on the PC with a stan-
dard USB cable (plug combination - Mini-B type / Type A).
The distance between safety sensor and PC is limited to 5m if a standard USB cable is used.
Use active USB cables if longer cable lengths are required.
NOTICE
Ä If possible, use the ready-made cables from Leuze (see chapter 18 "Order guide and acces-
sories").
• Connect the USB cable to the safety sensor and the PC.
• Select the LAN/USB (RNDIS) interface for the device search.
• Start the device search by clicking the [Start] button.
• Select the safety sensor from the list of found devices.