Lexmark C522 - Page 54

2-22 Service Manual
5022-xxx
54 Network <x>
software error
• Press until Continue appears, and then press to clear the message and
continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• POR the printer. If this does not fix the problem, replace the PCI card.
55 Unsupported option
in slot <x>
• Turn the printer off.
• Unplug the power cord from the wall outlet.
• Remove the unsupported option.
• Connect the power cord to a properly grounded outlet.
• Turn the printer on.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
56 Parallel port <x>
disabled
56 Standard parallel port
disabled
• Press until Continue appears, and then press to clear the message.
The printer discards any data received through the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
56 Serial port <x>
disabled
• Press until Continue appears, and then press to clear the message.
The printer discards any data received through the serial port.
• Make sure the Serial Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
56 Standard USB port
disabled
• Press until Continue appears, and then press to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
58 Too many flash
options installed
• Turn off and unplug the printer.
• Remove the excess flash memory.
• Plug in the printer, and turn it on.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
58 Too many trays
attached
This printer does not support the 500-sheet assembly.
• Turn off and unplug the printer.
• Remove the 500-sheet paper tray assembly.
• Plug in the printer, and turn it on.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
61 Remove defective
disk
• Press until Continue appears, and then press to clear the message and
continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
User status and attendance messages (continued)
Error code Action