Diagnostic information 2-23
5022-xxx
62 Disk full
• Press until Continue appears, and then press to clear the message and
continue processing.
Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
63 Unformatted disk
• Press until Continue appears, and then press to clear the message and
continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
64 Unsupported disk
format
• Press until Continue appears, and then press to clear the message and
continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
80 Fuser life warning
• Press until Continue appears, and then press to clear the message and
continue printing.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
• If this does not fix the problem, replace the system card.See “System card removal” on
page 4-79.
80 Replace fuser • Replace the fuser.
• If this does not fix the problem, replace the system card. See “System card removal” on
page 4-79.
82 Waste toner box
nearly full
• Press until Continue appears, and then press to clear the message and
continue printing.
• If printing continues, order a replacement waste toner box immediately.
• If the problem persists, open the front access door and check the bump aligner shaft for
binding. Clear the binding if possible. If not possible, contact your next level of service.
82 Replace waste toner
box
• Replace the waste toner box using the instruction sheet that comes with the replacement
waste toner box.
• Ensure that there is no interference between the waste toner box and the printer.
• If the problem persists, open the front access door and check the bump aligner shaft for
binding. Clear the binding if possible.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
• If the problem persists, contact your next level of service.
User status and attendance messages (continued)
Error code Action
To Next Page
Loading...
