2-24 Service Manual
5022-xxx
82 Waste toner box
missing
• Insert the waste toner box.
• Inspect the top cover camshaft assembly for proper operation. When the top access cover
is closed, the printer should mechanically interlock.
• Check the JBUMP1 connection/cable connected to the system card for defects and
proper connection. If the cable wiring or the cable connection is defective, replace the
bump aligner motor. See “Bump aligner motor removal” on page 4-40. If the JBUMP1
connector is damaged on the system card, replace the system card. See “System card
removal” on page 4-79.
• Check the bump aligner shaft and the mechanical system for binds.
• Replace the bump aligner motor. See “Bump aligner motor removal” on page 4-40.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
83 Transfer belt missing • Insert the transfer belt.
• For models C52x: Check connector JTRANS1 for proper connection to the system card,
the cable for pinch points, and the cable or connector for any other damage. If the
connector is damaged on system card, replace the system card. See “System card
removal” on page 4-79.
For models C53x: Check connector JTRANS2 for proper connection to the system card,
the cable for pinch points, and the cable connector for any other damage. If the connector
is damaged on the system card, replace the system card. See “System card removal”
on page 4-79.
If the JTRANS1 cable (model C52x) or the JTRANS2 cable (model C53x) is damaged,
replace the front door assembly. See “Front door assembly removal” on page 4-55.
• Replace the transfer belt assembly. See “Transfer belt removal” on page 4-91.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
83 Transfer belt life
warning
• Press until Continue appears, and then press to clear the message and
continue printing.
• Order a replacement transfer belt. When print quality is reduced, install the new transfer
belt using the instruction sheet that comes with the replacement transfer belt.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
83 Replace transfer belt • Replace the transfer belt using the instruction sheet that comes with the replacement
transfer belt. See “Transfer belt removal” on page 4-91.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
84 <color> PC Unit life
warning
• Press until Ignore appears, and then press to clear the message and continue
printing.
• Order the specified photoconductor unit. When print quality is reduced, install the new
specified photoconductor unit using the instruction sheet that comes with the replacement
specified photoconductor unit.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
84 Replace <color> PC
Unit
• Replace the specified photoconductor unit using the instruction sheet that comes with the
replacement specified photoconductor unit.
• If the problem persists, replace the system card. See “System card removal” on
page 4-79.
User status and attendance messages (continued)
Error code Action
To Next Page
Loading...
