Error code Description Action
242.24 DC Feed autocompensator stalled on the last pick
attempt in tray 2.
Go to “Option tray jam service check” on page 81.
242.32 Tray not ready.
242.33 Pick received but detected a tray pulled.
242.41 Motor 1 (Pick/Lift) Elevator motor stalled.
242.42 Motor 1 (Pick/Lift) Elevator motor PWM overflow
error (underspeed). Motor underspeed (max PWM
and motor underspeed, typical accordion jam).
Go to “Option tray jam service check” on page 81.
242.43 Motor 1 (Pick/Lift) motor ramp (end ramp - did not
reach speed, typical pack feed paper jam).
242.44 Motor 2 (Separator/Passthru) motor stalled.
242.45 Motor 2 (Separator/Passthru) motor PWM overflow
error (underspeed). Motor underspeed (max PWM
and motor underspeed, typical accordion jam).
242.46 Motor 2 (Separator/Passthru) motor ramp (end ramp
- did not reach speed, typical pack feed paper jam).
242.47 Motor 3 motor stalled. Go to “Option tray jam service check” on page 81.
242.48 Motor 3 motor PWM overflow error (underspeed).
Motor underspeed (max PWM and motor
underspeed, typical accordion jam).
242.49 Motor 3 motor ramp (end ramp - did not reach speed,
typical pack feed paper jam).
243.01 Paper over tray 3 pass thru sensor on warmup.
243.02 Input sensor detected late feed during a pick retry
from tray 3.
Go to “Option tray jam service check” on page 81.
243.03 tray 3 pass thru sensor never became covered when
feeding a sheet from an option below.
243.06 Failed to feed from tray. Paper present sensing
supported and indicates media still in tray.
243.07 Option tray 3 pass thru sensor never became
uncovered when feeding a sheet from an option
below.
243.09 Tray 3 pick motor lost encoder. Go to “Option tray jam service check” on page 81.
243.10 Failed to feed from tray.
243.11 Autocomp Pick / Lift Motor - Encoder never detected
in tray 3.
243.12 Motor ramp up error in tray 3.
4514-220, -230
Diagnostic information
76
To Next Page
Loading...
