Error code Description Action
243.49 Motor 3 motor ramp (end ramp - did not reach speed,
typical pack feed paper jam).
Go to “Option tray jam service check” on page 81.
244.01 Paper over tray 4 pass thru sensor on warmup.
244.02 Input sensor detected late feed during a pick retry
from tray 4.
244.03 Tray 4 pass thru sensor never became covered when
feeding a sheet from an option below.
244.06 Failed to feed from tray. Paper present sensing
supported and indicates media still in tray.
Go to “Option tray jam service check” on page 81.
244.07 Option tray 4 pass thru sensor never became
uncovered when feeding a sheet from an option
below.
244.09 Tray 4 pick motor lost encoder.
244.11 Autocomp Pick / Lift Motor - Encoder Never Detected
in tray 4.
244.12 Motor ramp up error in tray 4. Go to “Option tray jam service check” on page 81.
244.13 Page to be stapled failed to feed from tray.
244.14 Sheets flushed from paper path either due to feed
error or cartridge error.
244.15 One or more trays located above the source tray 4 has
been pulled.
244.16 The engine timed out waiting for the tray 4 to report
'ready' before the 1st pick attempt.
Go to “Option tray jam service check” on page 81.
244.17 Page was not properly picked from tray 4. Have not
exhausted all pick retry attempts as there are sheets
committed to the paper path from below.
244.19 Tray 4 fail to feed error. Detected while trying to pick
a sheet, and that leading edge was not detected by
tray sensor.
244.20 Took too long to ramp up dc feed motor in tray 4.
244.21 Pick motor stall in tray 4. Go to “Option tray jam service check” on page 81.
244.22 Tray 4 pick motor underspeed.
244.24 DC Feed autocompensator stalled on the last pick
attempt in tray 4.
244.32 Tray not ready.
4514-220, -230
Diagnostic information
78
To Next Page
Loading...
