Error code Description Action
244.33 Pick received but detected a tray pulled. Go to “Option tray jam service check” on page 81.
244.41 Motor 1 (Pick/Lift) Elevator motor stalled.
244.42 Motor 1 (Pick/Lift) Elevator motor PWM overflow
error (underspeed). Motor underspeed (max PWM
and motor underspeed, typical accordion jam).
244.43 Motor 1 (Pick/Lift) motor ramp (end ramp - did not
reach speed, typical pack feed paper jam).
244.44 Motor 2 (Separator/Passthru) motor stalled. Go to “Option tray jam service check” on page 81.
244.45 Motor 2 (Separator/Passthru) motor PWM overflow
error (underspeed). Motor underspeed (max PWM
and motor underspeed, typical accordion jam).
244.46 Motor 2 (Separator/Passthru) motor ramp (end ramp
- did not reach speed, typical pack feed paper jam).
244.47 Motor 3 motor stalled.
244.48 Motor 3 motor PWM overflow error (underspeed).
Motor underspeed (max PWM and motor
underspeed, typical accordion jam).
244.49 Motor 3 motor ramp (end ramp - did not reach speed,
typical pack feed paper jam).
[x]‑page jam, remove tray [x]. [24y.xx]
1 Pull out the tray completely.
2 Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
4514-220, -230
Diagnostic information
79
To Next Page
Loading...
