Lexmark T650 - Page 157

Diagnostic information 2-123
4062
985.07 Service engine RFID
communications
Antenna is disconnected 1. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to “High
capacity input tray (HCIT)
pick arm bracket
assembly removal” on
page 4-130.
2. Replace the RFID UHF
option.
Note: There can be no other
connectivity options installed
on printers that have the RFID
UHF option installed. If any
connectivity option is installed
(other than the RFID interface
card), a 985.xx error will occur
990.00 Output option
equipment check.
Output option rear door not
fully closed.
Close the rear door on all
output options.
990.02 Paperport failure Invalid paperport parameter Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
990.03 Paperport failure Invalid paperport protocol Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
990.04 Paperport failure Unsupported paperport
command
Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
990.06 Paperport failure Unknown page supervisor
state
Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
990.09 Paperport failure Paperport framing error Replace the system card
assembly.
Go to “System card
assembly removal (T650,
T652, T654, T656)” on
page 4-76.
Error
code or
message
Error contents Description/Action Possible repair actions