Lexmark T650 - High Capacity Input Tray (HCIT) Tray Lift Drive Motor Assembly Removal

Repair Information 4-125
4062-XXX
3. Remove the HCIT drawer slide.
High capacity input tray (HCIT) tray lift drive motor assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT cover, right. Go to “High capacity input tray (HCIT) cover, right removal” on
page 4-120.
2. Remove the HCIT cover, left. Go to “High capacity input tray (HCIT) cover, left removal” on page 4-122.
3. Disconnect the HCIT tray lift drive motor cable connector from the HCIT controller card assembly.
Note: Remove the cable from the restraint, and observe the routing for reinstallation.
4. Remove the eight screws (A) securing the HCIT tray lift drive motor assembly.
A
A