2-148 Service Manual
4062
Sensor (stapler pass through) late jam service check
2
Check the appropriate media tray sensor (pass through) for
proper operation.
1. Enter the diagnostic mode
2. Select Input tray tests
3. Sensor test
4. Select the appropriate tray number
3. Observe the line item “pass through” for the appropriate
media tray
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
Go to step 5. Go to step 4.
3
Check the above sensor for proper connection.
Is the above sensor connected properly?
Replace the
appropriate sensor
(pass through).
Go to “250-sheet
controller card
assembly
removal” on
page 4-106.
Replace the
connection.
4
Perform a print test using the appropriate input tray.
Does the error continue?
Replace the input
option.
Problem solved.
Step Check Yes No
1 Check the output option for proper installation.
Is the above component properly installed?
Go to step 2. Remove then
reinstall the output
option
2
Check for obstructions in the media path between the base
machine and the output option.
Is the media path free from obstructions?
Go to step 3. Remove
obstructions.
3
Check the sensor (stapler pass through) for proper
operation.
1. Enter the diagnostic mode
2. Select Finisher sensor test
3. Select Sensor test
4. Select pass & media
5. Observe the line item “passthru”
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
Go to step 5. Go to step 4.
4
Check the above sensor for proper connection.
Is the above sensor connected properly?
Replace the
stapler unit
assembly.
Go to “SFP
stapler assembly
stapler unit
assembly
removal” on
page 4-182.
Replace the
connection.
Step Check Yes No
To Next Page
Loading...
