Lexmark T650 - Redrive Assembly Removal (T650, T652, T654)

4-62 Service Manual
4062-XXX
3. Remove the metal cover.
4. Disconnect the connections (B) from the printhead assembly.
5. Remove the four screws (C) securing the printhead assembly to the machine.
6. Remove the printhead assembly.
Replacement Warning: When replacing the printhead assembly, ensure that the printhead skew is properly
adjusted, or print quality issues will occur.
Redrive assembly removal (T650, T652, T654)
1. Remove the door assembly, rear. Go to “Door assembly, rear removal (T650, T652, T654)” on
page 4-15.
2. Open the fuser access door.
3. Remove the two screws (A) securing the redrive assembly to the machine.
4. Press the two tabs (B) to release the redrive assembly to the machine.
B
C