Lexmark T650 - Sensor (HCIT Tray Raised HP) with Cable Assembly Removal; Stapler;Stacker Controller Card Assembly Removal

4-192 Service Manual
4062-XXX
Stapler/stacker controller card assembly removal
1. Remove the left cover. Go to “SFP stapler assembly left cover removal” on page 4-173.
2. Disconnect all harnesses to the controller card.
3. Remove the three screws (A) securing the stapler/stacker controller card assembly.
4. Remove the stapler/stacker controller card assembly.
Sensor (HCIT tray raised HP) with cable assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT cover, left. Go to “High capacity input tray (HCIT) cover, left removal” on page 4-122.
A