Lexmark T650 - Paper and Specialty Media Guidelines; Paper Guidelines

2-32 Service Manual
4062
203.10 Redrive motor control
failure.
Media tray 1
The redrive motor does not
reach the proper operating
speed at the specified time.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal (T650,
T652, T654)” on
page 4-62.
203.18 Redrive motor
assembly underspeed
error.
The redrive motor assembly
does not rotate at the specified
speed.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal (T650,
T652, T654)” on
page 4-62.
203.20 Redrive motor lost
encoder failure
The redrive motor is not
reporting pulses back to the
engine.
1. Check all connections on
the redrive motor assembly.
2. Check all connections on
the system card assembly.
3. Replace the redrive motor
assembly if problem
remains. Go to “Redrive
assembly removal (T650,
T652, T654)” on
page 4-62
230.00 Paper jam around
internal duplex.
Source = Internal
duplex
Page may be jammed in
internal duplex area.
1. Remove all media present
in media path.
2. Check for obstructions in
media path.
3. Go to sensor (fuser output)
service check. See
“Sensor (fuser output)
service check” on
page 2-126.
4. Go to sensor (duplex input)
service check. See
“Sensor (duplex input)
service check” on
page 2-127.
230.01 Sensor (duplex input)
lingering jam
Source = Internal
duplex
Media reached the sensor
(duplex input) but did not clear
it in the specified time.
Go to sensor (duplex input)
lingering jam service check.
See “Sensor (pass through)
late jam service check” on
page 2-145.
Error
code or
message
Error contents Description/Action Possible repair actions