EXTERNAL EQUIPMENT SETUP
24
EXTERNAL EQUIPMENT SETUP
GG
To get the the best picture quality, adjust the PC
graphics card to 1280x768, 60Hz.
GG
Depending on the graphics card, DOS mode may
not work if a HDMI to DVI Cable is in use.
GG
When Source Devices are connected with
HDMI/DVI Input, the output PC Resolution(VGA,
SVGA, XGA), Position and Size may not fit on the
Screen. As shown in the picture below, press the
OK button to adjust the screen Position of the TV
SET and contact a PC graphics card service cen-
ter.
GG
When Source Devices connected with HDMI/DVI
Input, output TV SET Resolution (480p, 576p,
720p, 1080i, 1080p) and TV SET Display fit
EIA/CEA-861-B Specification to Screen. If not,
refer to the Manual of HDMI/DVI Source Devices
or contact your service centre.
GG
If the HDMI/DVI Source Device is not connected
to the Cable or if there is a poor cable connec-
tion, "No signal" is displayed in the HDMI/DVI
Input. In this case, that Video Resolution is not
supported. If "Invalid Format" is displayed, refer to
the Source Device manual or contact your service
centre.
GG
Avoid keeping a fixed image on the screen for a
long period of time. The fixed image may become
permanently imprinted on the screen.
GG
The synchronization input form for Horizontal
and Vertical frequencies is separate.
NOTES
To Next Page
Loading...
