D9U003VS0-0101_01
51
OptiCare for Multicare
AUTOMATIC CALIBRATION
Automatic Calibration occurs each 3 months.
Automatic Calibration is automatically interrupted during intervention of patient or hospital sta .
If the Automatic Calibration is interrupted it will appear again after 10 hours. Following screen appears during this process.
To nish the Automatic Calibration:
► wait until the Automatic Calibration ends.
Fig. Automatic Calibration
PRESSURE OPTIMISATION DISABLED
Pressure Optimization is stopped when:
► the mattress support platform is tilted by 10 and more degrees (Anti-Trendelenburg Tilt)
► the mattress support platform is tilted by 10 and more degrees (Lateral Tilt)
► the mattress support platform is tilted by 5 and more degrees (Trendelenburg Tilt)
► tilt reduction of the mattress support platform has value of 7 or less degrees (Anti-Trendelenburg Tilt)
► tilt reduction of the mattress support platform has value of 7 or less degrees (Lateral Tilt)
► tilt reduction of the mattress support platform has value of 3 or less degrees (Trendelenburg Tilt)
Fig. Pressure Optimisation Disabled
To Next Page
Loading...
