Link Controls CS 320 - Expert Menu; Reset

28 – Control CS 320 / Rev.D 1.01 Control CS 320 / Rev.D 1.01 – 29
EN
Operating mode 3: INPUT
The values of various parameters can be changed in INPUT
mode.
Display:
− Displays the selected parameter
− Displays the status/value set
Operating mode 4: DIAGNOSIS
Door-speciccheckscanbeinterrogatedinDIAGNOSISmode.
Display:
− Display of the check
− Display of the check status
8.3 8.3 Expert menuExpert menu
Under factory settings (standard), only a few parameters
appear in the INPUT operating mode, which can be adjusted
bytheoperator.Thesesettingparametersreectthemost
frequently applied requirements for an industrial door system
andaresufcientforcommissioninginastandardsituation.
Thelastiteminthislististhe“EXPERTMENU”parameter.
This is always set to OFF.
OFF: Limited number of parameter settings:
− Menu language
− INT POS UP
− OPEN TIME
− FOREWARNING TIME
− FAST CLOSE
− REVERSE OFF
− INPUT 1
− SELF LOCK
− EXPERT MENU
Setting the EXPERT MENU parameter to ON activates the
expert mode. It is now possible to call up and set all input
menu parameters.
Ô “10.2Inputoperatingmode”
Note
− The expert mode is automatically exited after approx.
7minutes,ifnobuttonispressed.Now,onlythelimited
selection of parameters is once again available until the
EXPERT MENU parameter is set to ON again.
− The same applies to switching off the power. This once
again sets the EXPERT MENU parameter to OFF.
8.4 8.4 RESETRESET
The RESET function can be used to reset the control
parameters to the pre-selected factory settings.
Ô “10.2Inputoperatingmode”
FACTORY SETTING parameter
Selection of the parameter set that should be reset with a
RESET.
It is possible to implement different types of reset whereby
more or less settings are reset.
Ô “10.2Inputoperatingmode”
RESET parameter
Part reset 1 :
All parameter settings are reset, apart from the settings for
thefrequencyconverter(onlywithCS320FU).
Part reset 2 :
All parameter settings are reset, apart from the settings for
the limit positions and the detected limit position system.
Full reset :
Everything is reset to factory settings.
Ô “8.5RESETTINGthecontrollerwithLCDmonitor”
Ô “8.6RESETTINGthecontrollerwithoutLCDmonitor”