Link Controls CS 320 - Product Overview; Product Description; Variants

4 – Control CS 320 / Rev.D 1.01 Control CS 320 / Rev.D 1.01 – 5
4 – Control CS 320 / Rev.D 1.01
Instructions regarding installation and connection
− The control is designed with X type terminals.
− The system must be disconnected from the electricity supply
before carrying out any electrical work. It must be ensured
that the electricity supply remains disconnected for the
duration of the work.
− Local protective regulations must be complied with.
− Consultthemanufacturerbeforecarryingoutmodications
or replacing the mains connection cable.
− In general, an original wiring harness from Marantec
LegdenGmbH&Co.KGshouldbeusedforestablishingthe
connection between the door drive and controller. Changes
or replacements shall only take place following consultation
with the manufacturer and approval by the same.
Information concerning operation
− Unauthorised persons (particularly children) should not be
allowed to play with permanently installed adjusting or
control devices.
− Keep remote controls beyond the reach of children.
Observe the valid standards and regulations!
4. Product overview
4.1 4.1 Product descriptionProduct description
ThecontrollerCS320isdesignedforuseinindustrialareas
and can be used with all door types in these areas. It is
possible to connect drives with mechanical limit switches
(MEC) or an electronic limit position system (AWG).
All the necessary command devices and safety elements can
be connected, set and evaluated.
Programming takes place via a pluggable LCD monitor.
Alternatively, a service tool is available as an accessory.
The service tool consists of a stick and an app.
ThefollowingsuppliervariantsofthecontrollerCS320are
possible:
4.2 4.2 VariantsVariants
Housing variants:
− ControllerCS320inthe“standard”housing
− ControllerCS320inthe“combination”housingwith
integrated mounting rail for additional components
Variants of the pluggable LCD monitor:
− LCD monitor on the circuit board
− LCD monitor in the housing cover
− Hard-wiredLCDmonitor,pluggable(MSBUS)
− Without LCD monitor (monitor is required for all settings
apart from the limit position setting)
Command device variants:
− 3-fold button CS integrated in the housing
Optional:
− Housingwithout3-foldbutton
− HousingwithON/OFFkeyswitch
− Housingwithmainswitch
− Housingwithemergencystop
− Pluggable components (circuit board)
− Brake monitoring module
− Week timer
− Radio receiver
− Radio transmission system for closing edge protective
device and/or a safety element.
The operating instructions describe the connection
andprogrammingoptionsandvariantsoftheCS320
controller with connected LCD monitor and from software
versionV1.01a.
General safety instructions