Link Controls CS 320 - Document Overview and Safety; Information in this Document; General Safety Instructions

Control CS 320 / Rev.D 1.01 – 3
EN
2 – Control CS 320 / Rev.D 1.01 Control CS 320 / Rev.D 1.01 – 3
3. General safety instructions
WARNING!
Failure to comply with the documentation could
result in life-threatening danger!


Be sure to follow all the safety instructions in this
Be sure to follow all the safety instructions in this
document.
document.
Warranty
The function and safety of the equipment is only guaranteed
if the warning and safety instructions included in these
assembly instructions are adhered to.
The manufacturer is not liable for personal injury or damage
to property if these occur as a result of the warnings and
safety advice being disregarded.
The manufacturer does not accept any liability or warranty
for damage due to the use of non-approved spare parts and
accessories.
Intended use
ThecontrollerCS320isdesignedexclusivelyforcontrolling
door systems through drives with mechanical limit switches
(MEC) or an electronic limit position system (AWG).
Target group
Onlyqualiedandtrainedelectriciansmayconnect,
programme and service the control.
Qualiedandtrainedelectriciansmustmeetthefollowing
requirements:
− Knowledgeofthegeneralandspecicsafetyandaccident
prevention regulations,
− Knowledge of the relevant electrical regulations,
− Training in the use and care of appropriate safety
equipment,
− Capable of recognising the dangers associated with
electricity.
Original assembly instructions
− Copyright.
− No part of these instructions may be reproduced without
our prior approval.
− Subject to alterations in the interest of technical progress.
− All dimensions given in mm.
− The diagrams in this manual are not to scale.
Key to symbols
WARNING!
Indicates a hazard with a medium level of risk which, if not
avoided, could result in death or serious injury.
CAUTION!
Indicates a hazard with a low level of risk which, if not
avoided, could result in minor or moderate injury.
ATTENTION!
Indicates an imminent danger of damage or destruction.
CHECK
Indicates a check to be performed.
REFERENCE
Reference to separate documents which must be complied
with.
 Action requestAction request
− List, itemisation
Ô Reference to other sections of this document
2. Information in this document