19
User Manual
2.2.1 TURNING ON
Press and hold the right side of 'POWER' for 1 second. The chartplotter
emits one rapid beep sound and a title page is opened.
After a few seconds, the first of the two Caution Notice pages is displayed,
reminding you that the chartplotter is only an aid to navigation, and should be used
with appropriate prudence. The electronic charts are not intended to substitute for
the official charts. Then the cartographic screen is displayed.
2.2.2 TURNING OFF
Press the right side of 'POWER' and hold for 3 seconds: a countdown timer
appears on the screen, if you release the key before the countdown timer reaches
zero, the chart plotter will remain On.
2.3 CHANGING BACKLIGHT AND CONTRAST
Press and immediately release the right side of 'POWER' (do not press and
hold the key, or the "power-off" message will be displayed!): the backlight increases.
Repeat this operation the backlight decreases.
Press and immediately release the left side of 'POWER': the contrast increases.
Press and immediately release the left side of 'POWER' the contrast decreases. In
other words, first pressure of the key will increase the value till you keep it pressed,
next pressure of the key will decrease the value till you keep it pressed.
WARNING !!!
At very low temperatures the CCFL backlight may not glow properly. Allow a few minutes for
it to warm up.
2.4 SELECTING THE LANGUAGE
It is possible to select the language in which you wish information to be
displayed (for screen labels, menus and options, but it is not affect the map informa-
tion). The default setting is Italian.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "LANGUAGE" + 'ENTER'
Choose the language you prefer and press 'ENTER' to confirm.
To Next Page
Loading...
