89
User Manual
• Lost Target
When the AIS info is not received from that vessel for 3.5 minutes. The
presentation will be a flashing black triangle with a cross through.
• Activation Range
Range around your boat where targets become active. AIS target become
active within this range. Activation Range should be greater than CPA Limit
by definition.
Note
A target is removed from the screen if data is not received for 10 minutes.
The maximum number of tracked targets is 100.
Depending on the scale the presentation of the targets change to remove clutter on the screen.
This information is updated every 3 seconds to 6 minutes depending on speed and rate of turn,
enabling the track of the vessels in range to be plotted.
5.7.2 AIS MENU
To configure the chart plotter to receive AIS data, follow the procedure:
'MENU' + "AIS SETUP" + 'ENTER'
The AIS menu is shown on the screen, the items are described in the follow-
ing paragraphs.
5.7.2.1 Display
''MENU' + "AIS SETUP" + 'ENTER' + "DISPLAY" + 'ENTER'
Turns the display of AIS targets overlay on the cartography ON or OFF.
The default setting is ON.
5.7.2.2 Activation range
'MENU' + "AIS SETUP" + 'ENTER' + "ACTIVATION RANGE" + 'ENTER'
Defines the range from the fix within which the AIS Target becomes active.
The values allowed are from 0.1 to 20 Nm. The default setting is 5 Nm.
5.7.2.3 CPA Alarm
'MENU' + "AIS SETUP" + 'ENTER'+ "CPA ALARM" + 'ENTER'
Turns ON or OFF the alarm. The default setting is ON.
5.7.2.4 CPA Limit
'MENU' + "AIS SETUP" + 'ENTER' + "CPA LIMIT" + 'ENTER'
The values allowed are from 0.1 to 10 Nm. The default setting is 0.5 Nm.
5.7.2.5 TCPA Alarm
'MENU' + "AIS SETUP" + 'ENTER' + "TCPA ALARM" + 'ENTER'
To Next Page
Loading...
