35
User Manual
3.2.9 C-VOICE MENU
AVAILABLE ONLY IF THE CHARTPLOTTER IS CONNECTED TO VOICE NAVIGATION SYSTEM
The chartplotter has two different vocal modes, Navigation and Echosounder.
According to what mode is selected the messages spoken from the chartplotter are
different.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER'
3.2.9.1 Navigation
Enables (On), disables (Off) or insert the time (2, 5, 10, 15 minutes) for the
Navigation Voice mode. If it is On, the message is always sent, as fast as possible.
Instead if it is one among the available values, for example 2 minutes, the message is
sent related to the selected time, in the previous example every two minutes.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER' +
"NAVIGATION" + 'ENTER'
3.2.9.2 Echosounder
Enables (On) or disables (Off) the Echosounder Voice mode. If it is On, the
Depth message is spoken. The message is spoken if a valid depth data is received by
the chartplotter or if it is in Simulation mode. The default setting is Off.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER' +
"ECHOSOUNDER" + 'ENTER'
3.2.9.3 Output Port
Selects the Output Port for the Voice function. The default setting is Port 1.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "C- VOICE" + 'ENTER' + "OUTPUT
PORT" + 'ENTER'
3.3 A-B-C-D FUNCTION
The A-B-C-D function allows you to create the A, B, C, D points and to
delete them.
3.3.1 INSERTING THE A-B-C-D POINTS
Place the cursor on the desired position and press 'ENTER': the A point and
an information window on A appear. Move the cursor and press 'ENTER' again: the
B point appears, connected to A with a straight segment; an information window on
A-B segment (distance (DST), bearing (BRG) and total distance from the first point)
appears. Moving the cursor and pressing 'ENTER' places the C and D points:
To Next Page
Loading...
