4 -5
PTO gear lever
Parking brake lever
PTO switch
PARK
1. Press the clutch and brake pedal. Place the
shuttle lever, main gear shift lever in
NEUTRAL and PTO switch to OFF and
release the clutch pedal.
3. Pull the parking brake lever up and take foot
off from the brake pedal.
2. Push the position control lever forward to
lower implements to the ground. Turn key
switch to “OFF” position.
(4) Stopping tractor
1. Press the clutch pedal and brake pedals at
the same time to stop the tractor. Turn OFF
the key switch.
2. DO NOT release clutch pedal until all
moving parts have stopped.
(3) Emergency stop
3. Apply the parking brake.
Shuttle lever
Clutch pedal
Brake pedals
Throttle lever
Range gear
shift lever
Main gear
shift lever
(2) Changing speed
z Depress the clutch pedal fully and operate all the
shift levers correctly.
z Before shifting F/R Shuttle lever, Range gear
lever, Creeper gear (if fitted), HAVE TO STOP
the tractor completely.
Caution
▶ DO NOT depart from the tractor with the transmission gear placed in NEUTRAL
and the parking brake is not applied. The tractor may roll.
Apply the parking brake at all times before leaving the tractor.
▶ Remove the ignition key always after stopping engine.
To Next Page
Loading...
