4 -6
(5) Driving tractor on the road
z When facing downhill, DO NOT place the gear lever in NEUTRAL position.
z When driving the tractor on a unpaved road by attaching an implement to 3-point linkage, place the
gear lever to low speed and DO NOT lift the implement up to the highest position. When the tractor
bumps an obstacle, it may cause the jolting of implement and the failure of hydraulic system.
(In this case, place the position control lever on ¾ rising position of full stroke for safety.)
▶ Connect the left/right brake pedal with brake pedal connecting pin before driving.
▶ Avoid a sudden start, sudden brake and sudden turning.
▶ DO NOT allow people on the tractor or other implements.
▶ DO NOT place the baggage on the tractor or implement.
▶ Place PTO gear lever in neutral position and put the PTO switch in off position.
▶ DO NOT use the differential lock and four wheel drive (2WD use only).
▶ When traveling with implement on rear 3-point linkage, tighten the stabilizer to
avoid lateral movement.
▶ When traveling with implements installed, turn slowly by wide turning radius.
▶ While traveling, DO NOT ride your foot on the clutch pedal (if fitted) or brake pedal.
▶ While traveling, DO NOT operate any implement such as tiller, loader etc.
▶ When traveling or starting the tractor on an uphill, select the range shift gear
lever and main gear shift lever properly not to damage the engine and
transmission drive line. If not, especially for the power shuttle model, it may
cause damage to the power shuttle clutch by excessive abrasion.
Caution
DO NOT USE DIFF-LOCK
To Next Page
Loading...
