5 -22
(3) Changing Transmission oil
z Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.
z Set container under the drain plug and remove
drain plug under the transmission and drain oil
completely.
z Clean metal powder stuck to the drain plug and
tighten drain plug again with cooper washer.
z Add new oil until the oil level is between “Min”
and “Max” of the oil gauge.
z For oil specification and capacity, see section 5-
3, “Lubricants and Capacity” or the last page in
this manual.
(2) Changing Front axle oil
z Stop the tractor on a level surface and apply
parking brake.
z Remove all plugs for drainage, oil filling inlet and
oil check port on the center/left/right housing and
drain oil completely.
z Wrap the sealing tape on the plugs and tighten
the drain plugs.
z Add new oil into the oil filling inlet of the center
housing with checking if the oil flows out through
the oil check port.
For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil capacity : 8L (2.1 U.S gals.)
z Tighten the Oil check port plug on the center
housing.
z Add new oil into the left/right housing and tighten
the plugs.
Oil capacity : 2L (0.5 U.S gals.) – each housing
Total Oil capacity : 12 L (3.1 U.S.gals.)
Oil filling inlet
Drain plug
Drain plugs
▶ The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
Oil filling inlet
(center)
Oil check port
Oil filling inlet
(LH,RH)
To Next Page
Loading...
