3 -44
▶As the driving force of the rear axle is very high in creeper speed range, the tractor
may not be stopped even if pressing down the brake pedals. In this case, depress
the clutch pedal together when pressing down the brake pedals.
Caution
Creeper gear
lever
Creeper range
Standard range
(3) PTO gear lever
540 / 750 / 1000 rev/min and neutral position is
available.
Before operating the PTO gear lever, press the
clutch pedal and put PTO switch in “OFF”
position, and stop the PTO shaft completely.
750 rpm
PTO gear lever
(2) Creeper gear lever (if fitted)
It is used to engage/disengage the creeper
speed gear.
- Pull the lever upward for creeper speed
- Push it down for standard speed.
Before operating the creeper gear lever, press
down the clutch pedal, brake pedals and stop
the tractor completely.
If the range gear shift lever is in “H” position, it is
not possible to shift to the creeper speed range.
After changing the range gear shift lever to “L” or
“M” position, operate the creeper gear lever.
▶Operate the PTO gear lever by correct “I” pattern. If operated diagonally, it may
cause a failure.
Caution
1000 rpm
540 rpm
Neutral
To Next Page
Loading...
