5 -17
5-5. When the warning indicator lights
(1) Fuel filter warning indicator
Stop the engine, apply the parking brake and
cool down the engine.
Set container under the fuel pre-filter.
Disconnect electric wiring from sensor and
disassemble the water sensor.
Drain the contaminated fuel.
If the pure fuel begins to come out, tighten the
water sensor and connect the electric wiring to
the sensor.
Check if the fuel filter warning indicator is turned
off.
Water sensor
Fuel filter warning indicator
▶
Do not throw the exhausted waste fuel to any place. This may pollute the soil and
water seriously and also is prohibited legally. If violating, you would be responsible
for that by civil or criminal case. The waste oil must be disposed according to the
environment laws.
Caution
▶
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.
To help prevent possible injury, turn the key switch off when changing fuel filters or
water separator elements. Clean up fuel spills immediately.
Warning
▶
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel
system component that will be disconnected. Fit a suitable cover disconnected fuel
system component. Do not fill the new filter with fuel. Invisible fine contaminants
can enter the injection pump and it may cause damage to the fuel injection system.
Caution