3 -62
(3) Hydraulic lift control (Mechanical Hydraulic Lift, MHL) (if fitted)
Hydraulic lift device can work by position control, draft control and mixed control mode.
Position control lever
Draft control lever
Auto-lift control lever
Position control lever
Up
Down
① Position control
To set the position (height) of the rear implement,
move the position control lever up/down during
the engine is running. Generally, this lever is
used for tiller, fertilizer distributor, mower, rake
and other rear implements.
1.Push the position control lever forward and let
the implement down by its own weight.
2.Move up the lever to desired position, the rear
implement shell be located on the position
corresponding to the lever position.
3.To set the lowest position of the lever, turn
stopper A counter-clockwise, move and tighten it
at the desired position.
Stopper A
To Next Page
Loading...
