5 -19
Before starting engine, check the followings carefully to avoid any failure or damage.
5-6. Checking Before Starting (Daily check)
(1) Engine oil
Oil specification and capacity :
See chapter 5-3, “Lubricants and Capacity” or
the last page in this manual.
Checking engine oil level
- Check the engine oil level before starting
engine or at 5 minutes later after stopping
engine.
- Check if the oil level is between MAX and MIN
marks of the oil gauge. If necessary, add new oil.
- It must only be checked while the engine is
stopped.
- If your engine is operated in dusty/dirty
condition, the service interval must be shorter
than normal condition.
- Must replace the engine oil and engine oil filter
after the first 50 hours of use.
Oil filling inlet & oil gauge
Engine oil gauge
Wheel bolts and
tightening of
each part
Brake, Clutch
pedal operation
Engine coolant
level
Damage of Headlights,
Turn signal lights,
Horn etc.
Fuel & DEF
urea level
Cleanness of
radiator screen
Engine oil
level
Operation
of Indicators
Tire air pressure
and damage
Condition of air
cleaner primary
element
Transmission
oil level