4 -7
1. Lift up all the implements
(front/middle/rear) from the ground
after starting engine.
2. Pull the throttle lever to the low
speed position.
3. Place the power-shuttle lever in
neutral position.
4. Place the transmission gear levers
(Main, Range, Creeper gear lever)
on a suitable position.
5. Press down the brake pedals and
release the parking brake lever.
6. Place the power-shuttle lever to
forward/reverse position, and press
down the throttle pedal slowly when
the vehicle begins to start.
Throttle pedal
Power shuttle lever
Brake pedals
Parking brake lever
Range gear shift lever
② Power-shuttle / Power shift models
Position control
lever
Main gear shift lever
Throttle lever
▶When starting the power-shuttle or power shift models normally, use the power-
shuttle lever without depressing clutch pedal.
Notice
To Next Page
Loading...
