Lutron Electronics RadioRA - Page 21

RadioRA® Setup Guide 2-2
Advanced Programming
Section 2 - Advanced Features
Step 3 Remove a Dimmer, Switch, or
GRAFIK Eye® Control Unit
from the ALL ON button
Step 4 Complete the ALL ON button
programming
Simultaneously press and hold the 2nd and
4th buttons in the right most column until all
LEDs begin to flutter (approximately 3
seconds).
Turn OFF the Dimmer(s), Switch(es), or
GRAFIK Eye® Control Unit(s) that you want
removed from the ALL ON button
programming.
Dimmer
If you remove the wrong
Dimmer, Switch, or GRAFIK
Eye® Control Unit from the
ALL ON button, turn the
Dimmer, Switch, or GRAFIK
Eye® Control Unit ON to
reassign it.
Switch
OR
TRON
• Repeat Steps 1 through 4 to re-program
the ALL ON button any additional Master
Controls.
GRAFIK Eye®
Control Unit